AMD 2003 Annual Report Download - page 225

2.3. Conduct of Executing Works
All Works to be executed shall, in addition to being executed in a manner meeting the standards and requirements in other parts or provisions of this
Agreement, be executed in a manner meeting clean room standards as defined in Exhibit 3 Design.
Contractor explicitly acknowledges that Contractor is aware of the conditions and requirements of a 300 mm microprocessor wafer fabrication facility
and the standards to be met by such facility (which are far higher than the standards of regular industrial construction), especially those to be met by the
Works and Fab X, including, but not limited to, cleanroom conditions. Contractor explicitly warrants that Contractor sufficiently informs all
subcontractors of all conditions, requirements and standards to be met on or by such facility, including, but not limited to, cleanroom conditions.
Company has an absolute ban on smoking in place over the entire Site and in all its buildings, with the exception of smoking zones marked accordingly.
For reasons of personal and general safety, the consumption of any alcoholic beverages during work, or starting work in an intoxicated condition, is
prohibited. This also applies for other drugs.
Contractor hereby undertakes to strictly monitor compliance with these prohibitions on the part of its employees or the staff of any subcontractors used.
Repeated breaches or offences, in spite of a warning, shall be a valid basis for expulsion of the employee or the subcontractor from the Site.
2.4. Materials
Contractor shall, on demand of Company, submit for Company’s approval, detailed information, including, but not limited to, model number, quality,
manufacturer, about all materials Contractor intends to use. In addition, Contractor shall submit to Company, for Company’s approval, detailed
information about all materials which are exposed to parts of Fab X which are to be or might be operated under clean room conditions. Such approval
shall not unreasonably be withheld by Company.
12
Source: ADVANCED MICRO DEVIC, 10-K, March 09, 2004