CompUSA 2014 Annual Report Download - page 109

HVAC
- 29 -
Shipping Office Electrical Distribution:
•
20 - duplex wall outlets for general use
•
20 - Dedicated 20 amp duplex outlets (lunchroom vending machines, copiers, Gym
Equipment, etc.).
I.T. Room Electrical:
An independently derived 100 amp 208/120 volt / 3 phase (42 circuit) panel to be located in the I.T. room. The use of this panel will be exclusively for Global’s computer system and telephone
system. A 100 amp / 1 phase / 208 volt fused disconnect shall be included for tenant supplied
UPS and by pass switch located in the I.T. room (hook up included). In addition to general use
duplex outlets located on 4 walls there shall be two dedicated 120 volt quad outlet mounted on a
4’x8’ fire treated sheet of painted plywood (location by Global). There shall be two (2) 4”
conduits diversified from different street data carrier access points with pull string installed from
building data entry point to this plywood as well as two (2) 4” conduits from this plywood to the
open ceiling plenum outside of the I.T. room and two (2) 4” conduits from this plywood to
warehouse (ceiling) for Global Equipment Company’s network wiring points terminating in the
warehouse. A 6 gauge copper ground cable shall be installed from building ground to a ground
lug located on the above plywood. Conduits for building fiber and other data/telephone
connectivity to be provided from the suppliers’ street connection point to data room (IT room)
within the warehouse shipping office.
WH Office Lighting: Office lighting to be 2x2 LED (2x4 warehouse offices) (3500K) recessed lay in troffer basket
style with white perforated diffuser supplied by Juno Lighting Group (S2X2BP-45-35-U-
WH) or
approved equal. Fixtures in conference rooms to be on dimmable switches. Break room
controlled by PIR’s. Light fixtures grid shall start a maximum of 2’ from any wall. Office
lighting shall have a 50 foot candle minimum throughout the office area. One lighting contactor
switch to turn on/off lighting shall be provided by office entrance.
WH Office HVAC:
Builder/Developer will furnish and install roof top HVAC units with a standard system of
distribution ducts. Supply registers and diffuses, return grills and associated fixtures servicing the
warehouse shipping office area (4800 sq. ft.) and receiving office area (637 sq. ft.). The design
criteria shall be as to handle the heat load of the conditions of the building and 1 person per 60 sq.
ft. All units shall be designed with a (7) day programmable stat. Two separate 3 ton A/C cool only
split ductless units (Mitsubishi or approved equal) shall be provided for the I.T. room, supplied
with a low ambient control module with auto restart.
Warehouse Heat:
Reznor gas (natural) fired unit heaters provided throughout the warehouse to maintain building at
60 degrees (F) minimum @ 60” A.F.F. These units shall not be located in pallet racking areas as
per plan dated 10/8/14.
Warehouse Ventilation:
Warehouse roof top evaporative coolers to provide three (3) air rotations per hour (minimum)
controlled by 7 day (24 hr.) timers.
Warehouse Cooling: One (1) evaporative cooling unit (swamp cooler) shall be provided for every 10,000 S.F. of
warehouse space or as recommended by the design/build mechanical contractor.
Warehouse Forklift Charging Ventilation:
If required by code, an exhaust system shall be provided over the forklift battery charging area for
a minimum of 20 pieces of equipment (spaced ~5
’
on center) located by the warehouse office.