CompUSA 2014 Annual Report Download - page 108

ELECTRICAL
2000 amp, 480 volt/ 3 phase, four wire electrical service shall be provided for building lighting, power, and mechanical equipment. All
warehouse and office lighting will be 277v. All equipment and panels (Square D brand or equivalent. Note – Landlord will be utilizing Siemens
brand) shall be sized in accordance to NEC requirements. Electric switch gear(s) to be designed with a minimum of 8 “future” 3 phase breaker
spaces. Electric Service(s) to be wired and permitted for generators and transfer switches sized for a 500KW diesel (600 amps/480v) generator
for office operation (150 amps/480v) and warehouse (450 amps/480v). Generator to include 48 hour run tank and network maintenance
connectivity (by builder/landlord GC). Above generator to support ALL building operations (Lighting, office, fire pump, fire alarm, conveyor,
etc.) for a minimum of ¾ of the entire building going south to north.
- 28 -
Warehouse Electrical Distribution: In addition to warehouse lighting panels (480/277 volt) and low voltage distribution panels
(208/120 volt for dock levelers, general use convenience outlets, quad outlets between docks for
dock lights, etc.) the following panels shall be provided exclusively for Global’s warehouse
operation use (no lighting or HVAC units):
• Two (2) - 200 amp 480/277 volt/ 3 phase panel with 200 amp-208/120 volt/ 3 phase sub
panel (42 circuit) shall be provided in separate locations anywhere in the building as
indicated by Global.
These panels will be provided for Global’s use.
•
One (1) - 400 amp 480/277 volt / 3 phase panel with 200 amp sub panel 208/120 volt/ 3
phase (84 circuit each) shall be provided by the warehouse office. HVAC and lighting for
warehouse office may be powered from this panel.
•
All additional panels provided by electrical contractor to include a minimum of 30%
“spare” capacity.
Electrical contractor will include the following distribution from above panels (labor and
materials):
•
30 - Convenience quad outlets 120volt/ 20amp dedicated and located in the warehouse
by Global.
• 100 amp/480V/3 PH fused disconnect for a tenant provided conveyor panel (located in
60’ from dock of building x 200 ft from shipping office).
•
1 -
30 amp/480V/3 PH fused disconnect for a tenant provided air compressors (located in
60’ from dock of building x 100 ft from building side wall).
•
20 – Global supplied fork lift battery chargers (480 volt). These chargers to be mounted
on Global supplied and installed racks (fed from 400 amp panel listed above).
• 2 - Electric power hook up shall be provided (480 volt/3 phase) for tenant supplied trash
compactors.
Note:
Each interior dock light shall be 120 volt and use a quad outlet for power located next
to each dock door for maintenance use.
Warehouse Lighting:
High performance high bay 277 volt fluorescent fixtures with (T-5 lamps) and electronic instant start ballasts (program ready) with optically efficient reflectors and individual motion sensors
(aisle occupancy). Fixtures wired with relock and controlled by contactors (switches by
warehouse entrance) to provide 30 FC minimum @ 60” AFF. All fixtures to be mounted
between roof joists to avoid contact with racking systems and pallet placement and retrieval (this
applies to all areas throughout the warehouse (racked and staging). Fixtures to be @ 36’ A.F.F.
for 36’ clear height building. One lighting contactor switch to turn on/off lighting shall be
provided by warehouse office entrance.
•
Fixtures to be on a 18’8”centers (three rows per 56’bay) going the entire length of the
building x the dimension required to obtain 30 FC (@60” AFF) in a 120” pallet rack aisle
(for racked areas – see attached plan for pallet rack layout)
•
18’8” x the dimension required to obtain 30 FC (@60” AFF) in an open staging area (60
feet from docks X length of building X both sides).
If emergency lighting is required by code at each pallet rack aisle entry, builder/landlord/ GC
shall include at no additional cost based on rack layout supplied by Global dated 10/8/14.