AMD 1996 Annual Report Download - page 149

work for which record documents have not been properly maintained or submitted.
If CONTRACTOR fails to comply with the foregoing duties within a reasonable time
set by the COMPANY, then COMPANY shall be entitled to produce the record
documents at the expense of CONTRACTOR.
ARTICLE 29
OPERATION AND MAINTENANCE DATA
29.1 SUBMITTAL OF OPERATION AND MAINTENANCE DATA. "OPERATION AND
-------------------------------------------
MAINTENANCE DATA" is a written, printed, and drawn (including in electronic
form) presentation of data describing the operation, maintenance, and repair of
products and systems installed in the Project. CONTRACTOR shall, prior to
submitting its final payment request, submit to COMPANY ten (10) sets of
Operating and Maintenance Data describing all products, units or systems
installed in the Project. Approved shop drawings or record documents may serve
this purpose, but may require amplification as required by COMPANY.
29.2 CONTENTS OF DATA. Contractor shall provide the following information:
----------------
29.2.1 Product name and specification section under which it was
included.
29.2.2 Manufacturer's trade or brand name, catalog or model number,
and serial number (where applicable).
29.2.3 Name, address and telephone number of the installing or
applying subcontractor.
29.2.4 Name, address and telephone number of local supplier or
manufacturer's representative.
29.3 DATA FOR EQUIPMENT AND SYSTEMS. For equipment and systems, CONTRACTOR
------------------------------
shall provide the following information:
29.3.1 Manufacturer's parts lists and spare parts recommendations.
29.3.2 Manufacturer's published performance ratings, curves or
tables.
29.3.3 Manufacturer's diagrams or drawings of control and power
wiring.
29.3.4 Control system diagrams and sequence of operation
descriptions, including identification of final field settings of control
points.
29.3.5 Testing, balancing, and adjusting tabulations and reports.
29.3.6 Valve identification lists.
29.3.7 Piping systems identification or color coding tabulations.
29.3.8 Manufacturer's printed operation and maintenance instructions,
including (1) recommendations for lubrication and intervals at which service
should be performed, (2) trouble shooting suggestions, (3) adjusting and repair
directions.
29.3.9 CONTRACTOR prepared typewritten instructions, drawings,
diagrams or other information as necessary to supplement, clarify, or complete
the information supplied by the manufacturer.
63
Source: ADVANCED MICRO DEVIC, 10-K, March 20, 1997